Asbestos was found in some imported coloured sand products. New Zealand’s new rules will require specified sand-based products to be tested before they are supplied. The change follows research showing that asbestos fibres in some contaminated craft sands could become airborne during simulated play.

Coloured sand is often sold as a simple craft material or children’s toy. But recalls in Australia and New Zealand have shown that some sand products can contain asbestos. Research by Auckland University of Technology (AUT) has added a concerning detail: in simulated play and clean-up, asbestos fibres became airborne from nine of the ten contaminated craft-sand samples tested.

The findings are preliminary, and they do not mean that every sand product contains asbestos or releases fibres. They do show why relying on assumptions about how a product will be used can be a poor substitute for testing.

What did the AUT research find?

The AUT study examined 15 samples: ten craft-sand samples and four moulding-sand samples confirmed to contain asbestos, plus a control sample without asbestos.

Asbestos fibres became airborne during simulated play and clean-up involving nine of the ten craft-sand samples. No airborne fibres were detected in the tests involving the four moulding-sand samples or the control.

These results are specific to the products and conditions tested. The research is preliminary, so its findings should be interpreted with care. But the results challenge earlier reassurance that airborne fibres were unlikely unless contaminated sand was mechanically crushed or pulverised.

New Zealand’s product safety guidance now notes that contaminated fibres could become airborne during simulated play, creating the potential for people to inhale them. Asbestos is a known carcinogen, with the main health concern arising from breathing in asbestos fibres.

What will New Zealand require?

The Unsafe Goods (Consumer Sand Products) Notice 2026 takes effect on 1 February 2027. It prohibits the import and supply of specified sand-containing products unless mandatory testing and documentation requirements have been met.

The notice covers:

  • Toys containing accessible sand, including sand enclosed in flexible plastic, rubber, silicone, gel or elastomeric material
  • Decorative, artistic or craft products made from sand, or containing accessible sand

Examples include tubs of coloured sand, craft sand, rangoli products and stretchy sensory toys containing sand.

Testing must be carried out by an appropriately accredited laboratory, using one of the specified ISO 22262 methods. The laboratory must be accredited to ISO/IEC 17025 by an accreditation body.

Suppliers must hold a test report that identifies the product or product variant, the laboratory and method used, and confirms that no asbestos was identified in the samples tested. The report must be no more than 12 months old when the product is imported into or manufactured in New Zealand.

The notice does not cover every product containing sand. For example, it excludes naturally sourced sand intended to fill sandpits, playgrounds or other recreational areas, as well as board games without accessible sand.

The rule gives suppliers a clear responsibility: obtain suitable evidence for the product before it enters the New Zealand market. If testing identifies any amount of asbestos, New Zealand’s guidance says the product should be removed from sale, managed and disposed of in line with WorkSafe advice, and recalled.

Read the New Zealand unsafe goods notice and testing guidance and the notice published in the New Zealand Gazette.

How does this compare with Australia?

Australian health and product safety authorities previously described the risk to human health from recalled coloured sand products as very low, based on the evidence available at that time. AUT’s preliminary airborne-fibre findings were published later. Australian agencies have said they are considering the new research.

That timing matters. A risk assessment can change when new evidence becomes available. The practical question is whether Australia’s response will now move beyond managing recalled products and provide stronger safeguards against contaminated products reaching consumers in the first place.

New Zealand’s approach is preventive: for specified products, suppliers will need accredited test results before supply. It recognises that testing can identify contamination that cannot be detected by looking at the product, and that the way a product is actually played with matters when assessing risk.

What should suppliers do now?

Suppliers of coloured sand and sand-containing toys, craft materials or decorative products should review their product ranges and supply chains well before the New Zealand rules take effect.

That means confirming which products fall within the notice, obtaining testing through a suitably accredited laboratory, and ensuring the test report clearly identifies the product being supplied. A report for a similar product or a different variant may not provide reliable evidence for the product on sale.

Australian suppliers should also follow applicable recall and disposal advice for affected products, and keep informed as health authorities assess the AUT findings. “Low risk” is not the same as “no hazard”, and it should not be treated as a permanent conclusion when the evidence changes.

New Zealand has set a clear expectation for covered products: test before supply, document the result, and keep the evidence. Australia should consider whether the same preventive approach is needed here.

27 October 2026